Description
G4X PlugIn ECUs offer the latest in engine management technology, designed to easily maximize the potential from your car. This ECU fits inside the factory OEM enclosure. Installation is a breeze, with no alteration of the factory wiring loom required for the models listed below.
Designed for the 1JZ-GTE (Non-VVTi) engine.
- Please check your connector matches the header in the listed photo before purchasing.
- This ECU works for manual transmissions only.
- ECU includes an onboard 7 bar MAP sensor.
- Most factory features are supported. Check the features tab for I/O expansion options
Suitable applications:
- Toyota JZX90 (Chaser/Cresta/Mark II) with 1JZ-GTE (Non-VVTi) engine, Manual Transmission
- Toyota JZZ30 (Soarer) with 1JZ-GTE (Non-VVTi) engine, Manual Transmission
Note: This Plug-in features a new 4 pin powered CAN connector and cannot use the old CANPCB cable for CAN connection. Use the CANJST4 (Link PN 101-0198) cable for connecting CAN devices. This new 4 pin port and cable provide not only the CAN connection, but also a protected 12V power supply and ground for powering the CAN devices. The power supply is protected by a self-resetting fuse rated at 3A continuous.
G4X PlugIn Key Features (where applicable):
- Up to 6D fuel and ignition mapping
- Precision closed loop cam control (four cam, independent control)
- Sequential fuel delivery
- Digital triggering, all OEM patterns
- OEM idle hardware supported
- 5D boost control with three switchable tables
- Motorsport features – antilag, launch, flat shift
- Continuous barometric correction (on board)
- CAN port
- QuickTune – automated fuel tuning
- Individual cylinder correction
- USB tuning cable included
- Stats recording into on-board memory
- Gear compensations for spark, boost and fuel
- Real time selectable dual fuel, ignition and boost maps
- Sync and crank sensors can be a combination of Hall effect, variable reluctance or optical
- Boost control referenced to gear, speed or throttle position
- 512 mega bytes data logging memory
- Staged injection
- Knock with “windowing”
I/O Expansion Options:
The following expansion connector inputs/outputs are provided:
Expansion Connector 1 (J3)
Pin 1 Ground (signal)
Pin 2 +5v out
Pin 3 Injector 4
Pin 4 Injector 5
Pin 5 Injector 6
Pin 6 AUX 4
Pin 7 AN TEMP 4
Pin 8 AN TEMP 3
Expansion Connector 2 (J9)
Pin 1 Ground (signal)
Pin 2 +5v out
Pin 3 DI7
Pin 4 DI8
Pin 5 DI9
Pin 6 An Volt 8
Pin 7 An Volt 9
Pin 8 An Volt 10
E-Throttle Connector (J5)
Pin 1 Ground (signal)
Pin 2 +5V out
Pin 3 An Volt 4
Pin 4 An Volt 5
Pin 5 An Volt 6
Pin 6 An Volt 7
Pin 7 Aux 10
Pin 8 Aux 9
Reviews
There are no reviews yet.